Duda en packet tracer conectar dos routers!

[ruben_vmb]

De donde sacaste esto je,
Para conectar 2 routers en una interface por medio de un simulador los dos tendrian q estar en la misma red, tienes redes diferentes; ahora, uno tiene que ser DTE y el otro DCE, para esto quitale a uno lo del clock rate, asi mismo no entiendo porque el protocolo RIP si solo quieres conectar 2 routers no estas configurando las LAN's, o sea todo mal, por cierto te falta un protocolo en Capa 2

prueba asi

Router>
Router>enable
Router#confi
Router#configure ter
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Router(config)#interface serial 0/0/0
Router(config-if)#ip address 192.168.108.17 255.255.255.240
Router(config-if)#clock rate 64000
Router(config-if)#encapsulation ppp
Router(config-if)#no shutdown

%LINK-5-CHANGED: Interface Serial0/0/0, changed state to down
%SYS-5-CONFIG_I: Configured from console by console
Building configuration...
[OK]
Router#
%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up





ROUTER B
--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
Continue with configuration dialog? [yes/no]: n


Press RETURN to get started!



Router>
Router>
Router>enable
Router#confi
Router#configure ter
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#inter serial 0/0/0
Router(config)#interface serial 0/0/0
Router(config-if)#ip address 192.168.108.18 255.255.255.240
Router(config-if)#encapsulation ppp
Router(config-if)#no shutdown

%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up
Router(config-if)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up
Router(config-if)#exit
Router(config)#exit
%SYS-5-CONFIG_I: Configured from console by console
Router#copy ru
Router#copy running-config sta
Router#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Router#ping 192.168.108.17

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.108.17, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)

Router#ping 192.168.108.16

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.108.16, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)


Ahi me comentas
Saludos